In case only the CONFIG_SYS_I2C_SPEED is set in configuration file, the CONFIG_SYS_I2C_SOFT_SPEED is defined as CONFIG_SYS_I2C_SPEED. The CONFIG_SYS_I2C_SOFT_SPEED is then used throughout the driver.
Unfortunatelly, due to a typo in the driver, instead of defining CONFIG_SYS_I2C_SOFT_SPEED, an CONFIG_SYS_SOFT_I2C_SPEED was defined and therefore the driver failed to compile. The same applies for CONFIG_SYS_I2C_SOFT_SLAVE , where the swap happens as well. This patch fixes the issue. Signed-off-by: Marek Vasut <ma...@denx.de> Cc: Heiko Schocher <h...@denx.de> --- drivers/i2c/soft_i2c.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/drivers/i2c/soft_i2c.c b/drivers/i2c/soft_i2c.c index a2baec0..396fea8 100644 --- a/drivers/i2c/soft_i2c.c +++ b/drivers/i2c/soft_i2c.c @@ -105,11 +105,11 @@ DECLARE_GLOBAL_DATA_PTR; # endif #endif -#if !defined(CONFIG_SYS_SOFT_I2C_SPEED) -#define CONFIG_SYS_SOFT_I2C_SPEED CONFIG_SYS_I2C_SPEED +#if !defined(CONFIG_SYS_I2C_SOFT_SPEED) +#define CONFIG_SYS_I2C_SOFT_SPEED CONFIG_SYS_I2C_SPEED #endif -#if !defined(CONFIG_SYS_SOFT_I2C_SLAVE) -#define CONFIG_SYS_SOFT_I2C_SLAVE CONFIG_SYS_I2C_SLAVE +#if !defined(CONFIG_SYS_I2C_SOFT_SLAVE) +#define CONFIG_SYS_I2C_SOFT_SLAVE CONFIG_SYS_I2C_SLAVE #endif /*----------------------------------------------------------------------- -- 1.7.10.4 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
