Hi Fabio,
On 15/07/2013 04:40, Fabio Estevam wrote:
> From: Fabio Estevam <fabio.este...@freescale.com>
>
> mx6qsabrelite and nitrogen6q boards are hardware compatible, so let's avoid
> the
> code duplication and only use the nitrogen6x source code to make board code
> maintainance easier.
>
> Tested booting a mainline device tree kernel on a mx6qsabrelite board.
>
> Signed-off-by: Fabio Estevam <fabio.este...@freescale.com>
> ---
> .../nitrogen6x/README.mx6qsabrelite} | 0
> .../nitrogen6x/{README => README.nitrogen6x} | 0
> board/freescale/mx6qsabrelite/Makefile | 41 -
> board/freescale/mx6qsabrelite/mx6qsabrelite.c | 848
> ---------------------
> boards.cfg | 2 +-
> include/configs/mx6qsabrelite.h | 297 --------
> include/configs/nitrogen6x.h | 80 +-
Should we update the MAINTAINERS, too ? It is weird that we have two
maintainers for the same code.
Best regards,
Stefano
--
=====================================================================
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de
=====================================================================
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
