On Thu, Jul 11, 2013 at 4:52 PM, Nishanth Menon <n...@ti.com> wrote: > We do not use JFFS2 by default and it conflicts with > CONFIG_CMD_FS_GENERIC (ls command is the same). Since most of our > BOOTCMD can be simplified by using the FS_GENERIC, dropping JFFS2 > > Signed-off-by: Nishanth Menon <n...@ti.com> > --- > include/configs/omap3_beagle.h | 8 -------- > 1 file changed, 8 deletions(-) > > diff --git a/include/configs/omap3_beagle.h b/include/configs/omap3_beagle.h > index 48ce4c0..9adf4a5 100644 > --- a/include/configs/omap3_beagle.h > +++ b/include/configs/omap3_beagle.h > @@ -150,7 +150,6 @@ > #define CONFIG_CMD_CACHE > #define CONFIG_CMD_EXT2 /* EXT2 Support */ > #define CONFIG_CMD_FAT /* FAT support */ > -#define CONFIG_CMD_JFFS2 /* JFFS2 Support */ > #define CONFIG_CMD_MTDPARTS /* Enable MTD parts commands */ > #define CONFIG_MTD_DEVICE /* needed for mtdparts commands */ > #define MTDIDS_DEFAULT "nand0=nand" > @@ -203,13 +202,6 @@ > > #define CONFIG_SYS_MAX_NAND_DEVICE 1 /* Max number of NAND > */ > /* devices */ > -#define CONFIG_JFFS2_NAND > -/* nand device jffs2 lives on */ > -#define CONFIG_JFFS2_DEV "nand0" > -/* start of jffs2 partition */ > -#define CONFIG_JFFS2_PART_OFFSET 0x680000 > -#define CONFIG_JFFS2_PART_SIZE 0xf980000 /* size of jffs2 */ >
Minor nit, can we perhaps leave the JFFS configuration and only remove/comment CONFIG_CMD_JFFS. That way we wont lose these paritition offsets/size for folks who might need them. Otherwise, Acked-by: Joel Fernandes <jo...@ti.com> Thanks, -Joel _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
