Hi Tom,
Thanks for your quick reply.
2013/6/20 Tom Rini <tr...@ti.com>
> On Thu, Jun 20, 2013 at 12:27:02PM +0200, Enric Balletbo Serra wrote:
>
> > Hi all,
> >
> > I've some problems trying to boot a zImage with following command after
> > load the zImage and the fdt file on memory:
> >
> > U-Boot > fdt addr ${dtbaddr}; fdt resize; bootz ${loadaddr} - ${dtbaddr}
> [snip]
> > The same commands using the uImage instead of zImage works without
> > problems. Is expected to work ? Any clue before diving into the problem ?
>
> Same kernel tree? And you're setting bootargs before you do any of the
> above?
>
>
Yes, same kernel tree and I set the bootargs before. But I think it was my
bad, it's not an u-boot problem as I tested on beaglebone and works.
The difference between the two cases I tested are the address. The one that
doesn't work using zImage and works with uImage is
dtbaddr=0x81600000
loadaddr=0x80000000
If I change the addresses like the used in beaglebone, then works
dtbaddr=0x80200000
loadaddr=0x80F80000
I need to check exactly what is thge problem with these addresses. Anyway
it's not an u-boot problem. Thanks for the support.
Best regards,
Enric
--
> Tom
>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
