Hello,
Below is my board initialization process :
U-Boot 1.3.1 (Nov 27 2008 - 08:30:43) MPC83XX
Reset Status: Software Hard, External/Internal Soft, External/Internal Hard
CPU: e300c1, MPC8349E, Rev: 31 at 528 MHz, CSB: 264 MHz
Board: MPX8349GC
PCI1: 32 bit, 33 MHz
SRAM: 1 MB
I2C: ready
DRAM: 512 MB (DDR2, 64-bit, ECC on)
FLASH: 16 MB
PCI: Bus Dev VenId DevId Class Int
00 0f 10cf 202b 0380 00
In: serial
Out: serial
Err: serial
Net: TSEC0, TSEC1
During above initialization process of u-boot,
1. Does it conduct a test to all board hardware listed?
2. If above answer is yes, what method is used to do the test?
--
View this message in context:
http://www.nabble.com/U-boot-initialization-test-tp22840615p22840615.html
Sent from the Uboot - Users mailing list archive at Nabble.com.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
