[U-Boot] How do I use AM335x eth1 rather than eth0 ?

[Mark Jackson]

We have a dual Ethernet board (based on the BeagelBone) but with both Ethernet 
ports connected.

I'm wanting to use eth1 (rather than eth0), so in my board.c file, I changed:-

static struct cpsw_slave_data cpsw_slaves[] = {
        {
                .slave_reg_ofs  = 0x208,
                .sliver_reg_ofs = 0xd80,
                .phy_id         = 0,
        },
        {
                .slave_reg_ofs  = 0x308,
                .sliver_reg_ofs = 0xdc0,
                .phy_id         = 1,
        },
};

... to ...

static struct cpsw_slave_data cpsw_slaves[] = {
        {
                .slave_reg_ofs  = 0x308,
                .sliver_reg_ofs = 0xdc0,
                .phy_id         = 1,
        },
        {
                .slave_reg_ofs  = 0x208,
                .sliver_reg_ofs = 0xd80,
                .phy_id         = 0,
        },
};

... assuming that eth0 would now be ignored (as only 1 slave is configured).

But (eg) dhcp still only responds on eth0 !?!

What else do I have to change ?

Cheers
Mark J.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot