On Thu, Mar 19, 2009 at 01:30:36PM +0100, Stefan Roese wrote: > Currently the mtdparts commands are included in the jffs2 command support. > This doesn't make sense anymore since other commands (e.g. UBI) use this > infrastructure as well now. This patch separates the mtdparts commands from > the jffs2 commands making it possible to only select mtdparts when no JFFS2 > support is needed.
... and to make it useful for NAND chips as well, we should also remove now unrelated CONFIG_JFFS2_NAND. Note that struct part_info etc is in jffs2/load_kernel.h which is a bit misleading filename for that purpose, but that can be fixed later (tm). Signed-off-by: Ladislav Michl <[email protected]> diff --git a/common/cmd_mtdparts.c b/common/cmd_mtdparts.c index c8bf2c6..3d437c0 100644 --- a/common/cmd_mtdparts.c +++ b/common/cmd_mtdparts.c @@ -84,13 +84,10 @@ * */ -/* - * JFFS2/CRAMFS support - */ #include <common.h> #include <command.h> #include <malloc.h> -#include <jffs2/jffs2.h> +#include <jffs2/load_kernel.h> #include <linux/list.h> #include <linux/ctype.h> #include <cramfs/cramfs_fs.h> @@ -375,7 +372,7 @@ static int part_validate_nor(struct mtdids *id, struct part_info *part) */ static int part_validate_nand(struct mtdids *id, struct part_info *part) { -#if defined(CONFIG_JFFS2_NAND) && defined(CONFIG_CMD_NAND) +#if defined(CONFIG_CMD_NAND) /* info for NAND chips */ nand_info_t *nand; @@ -780,7 +777,7 @@ int mtd_device_validate(u8 type, u8 num, u32 *size) printf("support for FLASH devices not present\n"); #endif } else if (type == MTD_DEV_TYPE_NAND) { -#if defined(CONFIG_JFFS2_NAND) && defined(CONFIG_CMD_NAND) +#if defined(CONFIG_CMD_NAND) if (num < CONFIG_SYS_MAX_NAND_DEVICE) { #ifndef CONFIG_NAND_LEGACY *size = nand_info[num].size; _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
