Since we have DT support in exynos_fb and exynos_dp drivers now,
we need not define any static structure or platform data related to
display in the board file smdk5250.c.
So, we place the already existing structures inside #ifndef CONFIG_OF_CONTROL
block.
Signed-off-by: Ajay Kumar <ajaykumar...@samsung.com>
---
board/samsung/smdk5250/smdk5250.c | 14 +++++++++-----
1 file changed, 9 insertions(+), 5 deletions(-)
diff --git a/board/samsung/smdk5250/smdk5250.c
b/board/samsung/smdk5250/smdk5250.c
index 9e1e5db..1563bec 100644
--- a/board/samsung/smdk5250/smdk5250.c
+++ b/board/samsung/smdk5250/smdk5250.c
@@ -408,6 +408,12 @@ void exynos_cfg_lcd_gpio(void)
s5p_gpio_cfg_pin(&gpio1->x0, 7, GPIO_FUNC(0x3));
}
+void exynos_set_dp_phy(unsigned int onoff)
+{
+ set_dp_phy_ctrl(onoff);
+}
+
+#ifndef CONFIG_OF_CONTROL
vidinfo_t panel_info = {
.vl_freq = 60,
.vl_col = 2560,
@@ -440,11 +446,6 @@ vidinfo_t panel_info = {
.dp_enabled = 1,
};
-void exynos_set_dp_phy(unsigned int onoff)
-{
- set_dp_phy_ctrl(onoff);
-}
-
static struct edp_device_info edp_info = {
.disp_info = {
.h_res = 2560,
@@ -478,10 +479,13 @@ static struct exynos_dp_platform_data dp_platform_data = {
.edp_dev_info = &edp_info,
};
+#endif
void init_panel_info(vidinfo_t *vid)
{
+#ifndef CONFIG_OF_CONTROL
vid->rgb_mode = MODE_RGB_P,
exynos_set_dp_platform_data(&dp_platform_data);
+#endif
}
#endif
--
1.8.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
