Dear Otavio Salvador, [..] > /* > + * Status LED > + */ > +#define CONFIG_STATUS_LED > +#define CONFIG_GPIO_LED > +#define CONFIG_BOARD_SPECIFIC_LED > +#define STATUS_LED_BOOT 0 > +#define STATUS_LED_BIT 0x030a /* MX23_PAD_SSP1_DETECT__GPIO_2_1 */
Just use MX23_PAD_SSP1_DETECT__GPIO_2_1 directly ? > +#define STATUS_LED_STATE STATUS_LED_ON > +#define STATUS_LED_PERIOD (CONFIG_SYS_HZ / 2) > + > +/* > * MMC Driver > */ > #ifdef CONFIG_CMD_MMC Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
