Dear Yegor Yefremov, > On Thu, Nov 29, 2012 at 3:29 PM, Marek Vasut <ma...@denx.de> wrote: > > Dear Yegor Yefremov, > > > >> On Thu, Nov 29, 2012 at 1:55 PM, Marek Vasut <ma...@denx.de> wrote: > >> > Dear Yegor Yefremov, > >> > > >> >> On Thu, Nov 29, 2012 at 8:53 AM, Henrik Nordström > >> >> > >> >> <hen...@henriknordstrom.net> wrote: > >> >> > tor 2012-11-29 klockan 07:27 +0100 skrev Marek Vasut: > >> >> >> Dear yegorsli...@googlemail.com, > >> >> >> > >> >> >> > From: Yegor Yefremov <yegorsli...@googlemail.com> > >> >> >> > > >> >> >> > The driver code was taken from Linux kernel source: > >> >> >> > drivers/net/phy/icplus.c > >> >> >> > > >> >> >> > Signed-off-by: Yegor Yefremov <yegorsli...@googlemail.com> > >> >> >> > >> >> >> [...] > >> >> >> > >> >> >> Is there any user for this PHY please? > >> >> > > >> >> > I don't have one, but know at least one user having one in an A10 > >> >> > based "netbook". > >> >> > > >> >> > http://linux-sunxi.org/File:H6-netbook-mainboard.jpg > >> >> > >> >> I found these boards in kernel: > >> >> > >> >> arch/mips/configs/malta_defconfig:CONFIG_ICPLUS_PHY=m > >> >> arch/mips/configs/bcm47xx_defconfig:CONFIG_ICPLUS_PHY=m > >> >> arch/mips/configs/ip27_defconfig:CONFIG_ICPLUS_PHY=m > >> >> arch/mips/configs/sead3_defconfig:CONFIG_ICPLUS_PHY=y > >> >> arch/powerpc/configs/mpc512x_defconfig:CONFIG_ICPLUS_PHY=y > >> >> arch/powerpc/configs/52xx/motionpro_defconfig:CONFIG_ICPLUS_PHY=y > >> >> arch/powerpc/configs/83xx/mpc832x_rdb_defconfig:CONFIG_ICPLUS_PHY=y > >> >> arch/powerpc/configs/mpc83xx_defconfig:CONFIG_ICPLUS_PHY=y > >> >> arch/powerpc/configs/ppc6xx_defconfig:CONFIG_ICPLUS_PHY=m > >> > > >> > Sure, but the question/point is ... won't this be dead code in u-boot? > >> > It won't once you add at least one board that actually uses it ... > >> > adding it only so it's there will only cause it to bitrot and it'll > >> > actually only add more burden to maintainers. > >> > >> It won't be dead code, because we will use it :-) Our board is > >> derivative of BeagleBone & Co, so the whole support stuff is already > >> in u-boot. > > > > You need to enable it for that board though ;-) > > Will do this as soon as we come near to the release.
Release of what? The hardware? > I'd like to have basic stuff mainlined before. Well, I'll leave that up to Joe anyway Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
