Hi all I have been working on booting our custom MPC8548 board using a FDT. The board boots up to the point where "controll is passed to Linux" and then nothing happens. I have plased the final part of the console output at the bottom of this message.
Does anyone have an idea about what is going wrong? Is the error in my u-boot, device tree blob or linux kernel side? I am also not able to erase my flash in U-Boot (nor) does anyone know what i should look at? thanks pieter WARNING: adjusting available memory to 10000000 ## Booting kernel from Legacy Image at 00200000 ... Image Name: Linux-2.6.27 Image Type: PowerPC Linux Kernel Image (gzip compressed) Data Size: 1194002 Bytes = 1.1 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK kernel data at 0x00200040, len = 0x00123812 (1194002) ## Flattened Device Tree blob at 00800000 Booting using the fdt blob at 0x800000 of_flat_tree at 0x00800000 size 0x000037bc Uncompressing Kernel Image ... OK kernel loaded at 0x00000000, end = 0x00294a90 ## device tree at 0x00800000 ... 0x008037BB (len=26556=0x67BC) ## Transferring control to Linux (at address 00000000) ... Booting using OF flat tree... _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot