michael wrote:
> Stefan Althoefer wrote:
>
>> Jean-Christophe PLAGNIOL-VILLARD schrieb:
>>
>>
>>
>>>> diff -uprN u-boot-orig//lib_arm/board.c u-boot/lib_arm/board.c
>>>> --- u-boot-orig//lib_arm/board.c 2008-12-02 17:25:32.000000000 +0100
>>>> +++ u-boot/lib_arm/board.c 2008-12-02 23:29:36.000000000 +0100
>>>> @@ -441,6 +441,11 @@ extern void davinci_eth_set_mac_addr (co
>>>> }
>>>> #endif
>>>>
>>>> +#if defined(CONFIG_CMD_IDE)
>>>> + puts("IDE: ");
>>>> + ide_init();
>>>> +#endif /* CONFIG_CMD_IDE */
>>>>
>>>>
>>> are you sure it will work?
>>>
>>> Best Regards,
>>> J.
>>>
>>>
>> On my board (Janz emPC-A400 with IXP425) it does. With some more
>> patches to add IDE to this board.
>>
>> What is your doubt?
>>
>> If you see problems, drop this. I can also add IDE to board_late_init().
>>
>>
> I don't sure if the outsw/insw are implemented in arm.
>
> Regards Michael
> _______________________________________________
> U-Boot mailing list
> U-Boot@lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot
>
>
Well, I'm not sure :( if the outsw/insw are implemented in arm.
Regards Michael
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
