Dear Jens Scharsig, In message <[EMAIL PROTECTED]> you wrote: > > I am a little bit confused. We have designed a new AT91RM9200 based > board. It should boot from 16-bit NOR Flash. I have read many relevant > article in the forum, but I don't know , which board should I use as a > base. I have look at the actual source (2008.10 and git), and I think, > u-boot can't boot without a preloader as long CONFIG_AT91RM9200 is defined. > Is there an open patch to resolve this? > Can you get an example for a working implementation?
At least the at91rm9200dk and cmc_pu2 are supposed to boot from NOR flash - they did in earlier versions of U=-Boot, but probably have not undergone much testing lately. I have only the AT91RM9200DK in immediate access at the moment - this one boots 1.2.0-g14da5f76 just fine. If recent versions should not work any more it would be nice if someone with suitable hardware could run a git bisect to locate the culprit. Thanks in advance. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] If a packet hits a pocket on a socket on a port, And the bus is interrupted as a very last resort, And the address of the memory makes your floppy disk abort, Then the socket packet pocket has an error to report! - Ken Burchill? _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
