Doing trap_init immediately once we're running from RAM
means we're no longer dependent on the physical location of
the flash on non-BookE platforms. Before trap_init, those
platforms switch to real mode and go to 0xfff00100 on exception.
After the switch, they go to 0x00000100 This makes it easier to
move the flash location.
Signed-off-by: Becky Bruce <[EMAIL PROTECTED]>
---
lib_ppc/board.c | 10 +++++-----
1 files changed, 5 insertions(+), 5 deletions(-)
diff --git a/lib_ppc/board.c b/lib_ppc/board.c
index ce07c4e..289a32a 100644
--- a/lib_ppc/board.c
+++ b/lib_ppc/board.c
@@ -689,6 +689,11 @@ void board_init_r (gd_t *id, ulong dest_addr)
WATCHDOG_RESET ();
+ /*
+ * Setup trap handlers
+ */
+ trap_init (dest_addr);
+
#if defined(CONFIG_BOARD_EARLY_INIT_R)
board_early_init_r ();
#endif
@@ -765,11 +770,6 @@ void board_init_r (gd_t *id, ulong dest_addr)
asm ("sync ; isync");
- /*
- * Setup trap handlers
- */
- trap_init (dest_addr);
-
#if !defined(CONFIG_SYS_NO_FLASH)
puts ("FLASH: ");
--
1.5.5.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
