-----Ursprüngliche Nachricht----- Von: Anatolij Gustschin [mailto:[EMAIL PROTECTED] Gesendet: Freitag, 24. Oktober 2008 11:21 An: [EMAIL PROTECTED] Cc: Wolfgang Denk; u-boot@lists.denx.de Betreff: Re: [U-Boot] Splash Screen
Hello, Schmid Alexander wrote: >>>> Because when i press a key (between the 3 seconds of autostart) the >> splash >>>> screen picture stays there, and I don`t see any console output! >> >>> Try typing (blind): >>> >>> >>> setenv stdout lcd >>> >>> (followed by ENTER). What happens? >> >> When I type blind, the U-Boot acts normally( e.g reset or run bcmd_flash). >> But nothing happens if I do a"setenv stdout lcd". >> What could the reason be? >Maybe you should use "vga" instead of "lcd". Try: > setenv stdout vga OK thank you. It works. I played with the variables a time ago, and thought today, the whole morning, sdtout lcd sounds a little bit strange. But unfortunately "vga" was not in my head! Do you know were I could place the setenv stdout vga, that it will be automatically loaded when the 3 seconds autostart get interrupted from a key? Thanks very much. Best regards, Anatolij -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [EMAIL PROTECTED] _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
