Hello,
Dear Alexander, In message <[EMAIL PROTECTED]> you wrote: > > i have U-Boot running on MPC5200B! The U-Boot console output is on display! > Now i activated the splash sreen support, and it works! That's how itiis supposed to be :-) > But now I`m wondering, if I have a problem and have to do something in the > U-Boot console if I get there! You, of course you do. It just depends on how you set your I/O channels (stdin, stdout and stderr). >> Because when i press a key (between the 3 seconds of autostart) the splash >> screen picture stays there, and I don`t see any console output! >Try typing (blind): > > > setenv stdout lcd > >(followed by ENTER). What happens? When I type blind, the U-Boot acts normally( e.g reset or run bcmd_flash). But nothing happens if I do a"setenv stdout lcd". What could the reason be? > Has anyone an idea how I can solve that? I thaught about e.g. pressing ESC > and then I`m on U-Boot console or so? You have to assign the I/O channels to the devices you want to use, that's all. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] Of course there's no reason for it, it's just our policy. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
