Dear Heiko Schocher, In message <[EMAIL PROTECTED]> you wrote: > As Documented in README, adding a boardspecific Deblocking
Which part of the README are you referring to? > mechansim via CFG_I2C_INIT_BOARD for the mgcoge and mgsuvd > board. Are you talking about doc/I2C_Edge_Conditions? > This code was originally written by keymile in association > with Anatech and Atmel in 1998. The Code toggels the SCL > until the SCA line goes to High (max. 16 times). > And after this, a start Condition is send. > Signed-off-by: Heiko Schocher <[EMAIL PROTECTED]> > --- > board/keymile/common/common.c | 211 > +++++++++++++++++++++++++++++++++++++++++ > board/keymile/mgcoge/Makefile | 2 +- > drivers/i2c/soft_i2c.c | 11 ++ > include/configs/mgcoge.h | 1 + > include/configs/mgsuvd.h | 1 + > 5 files changed, 225 insertions(+), 1 deletions(-) > create mode 100644 board/keymile/common/common.c Hm... quoting doc/I2C_Edge_Conditions: ... Note that this is NOT necessary when using the bit-banging I2C driver (common/soft_i2c.c) as this already includes the I2C bus reset sequence. Can you please explain what your patch is doing differently, and why it is needed? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] A weak mind is like a microscope, which magnifies trifling things, but cannot receive great ones. -- Philip Earl of Chesterfield _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
