Hi This may be of interest
http://www.dxing.info/equipment/rolling_your_own_bryant.dx 73 Tony VK2IC On Fri, Mar 14, 2014 at 12:13 PM, Gary K9GS <[email protected]> wrote: > Can anyone point me to a design for a splitter for sharing a Beverage > antenna between two receivers? This is for Field Day so these are not > optimized Beverages by any means. > > Just want to allow the 80/40M stations to share antennas. Nothing fancy. > > My thoughts are to just use a CATV "2-Way" splitter at the output of the > Beverage matching transformer and run separate feed-lines to each radio. > I'm pretty sure these things work down to 1 MHz but have not measured them. > I can use the pre-amp in the radio (K3) to compensate for the loss. > > Thoughts? > > -- > > > 73, > > Gary K9GS > > Greater Milwaukee DX Association: http://www.gmdxa.org > Society of Midwest Contesters: http://www.w9smc.com > CW Ops #1032 http://www.cwops.org > > ************************************************ > > _________________ > Topband Reflector Archives - http://www.contesting.com/_topband > _________________ Topband Reflector Archives - http://www.contesting.com/_topband
