Well once you stop running it as sudo you're going to need to run the "installmgr -sc" step again to sync the config down from the server.
--Greg On Fri, Aug 29, 2014 at 4:56 PM, Jon Behrens <j...@crimsonthread.com> wrote: > Same result - > > jsb@jsb-VirtualBox:~/sword-1.7.3/utilities > cd ~/ > jsb@jsb-VirtualBox:~ > installmgr -ri CrossWire ESV > > Couldn't find remote source [CrossWire] > > jsb@jsb-VirtualBox:~ > sudo installmgr -ri CrossWire ESV > Remote source [CrossWire] does not make available module [ESV] > > > On 08/29/2014 03:51 PM, Greg Hellings wrote: > > Try running the installed version instead of the one in utilities. If you > executed "sudo make install" there should be a copy in /usr/local/bin > > --Greg > > > On Fri, Aug 29, 2014 at 4:50 PM, Jon Behrens <j...@crimsonthread.com> > wrote: > >> Thanks for the response Greg, but that doesn't work. Without being root: >> >> ./installmgr -ri CrossWire ESV >> Couldn't find remote source [CrossWire] >> >> ./installmgr -sc >> (Returns warnings and asks whether to proceed) >> enable? [no] yes >> Failed to sync config file with master remote source list. >> >> Jon >> >> >> >> On 08/29/2014 03:27 PM, Greg Hellings wrote: >> >> Try doing it as not root. I don't know why the docs suggest using root to >> do the work, but try doing it in your local directory by running the >> installmgr commands without being root. >> >> --Greg >> >> >> On Fri, Aug 29, 2014 at 4:15 PM, Jon Behrens <j...@crimsonthread.com> >> wrote: >> >>> Hello >>> >>> This started out as a C# binding question, but the problem is deeper >>> than that. Basically >>> I can't get the installmgr to do anything useful. I am new to Linux, but >>> have been writing software on other platforms for ~50 years. >>> >>> To insure that my machine configuration was not the problem (I had >>> installed Xiphos >>> and BibleTime earlier), I set up a new virtual machine using VirtualBox >>> and Mint 17. >>> >>> I updated all the packages and installed build-essentials. No other >>> software. >>> I downloaded Sword-1.73 and uncompressed it into a folder 'sword-1.7.3' >>> under my >>> home directory. >>> >>> I then followed the instructions in the INSTALL file and everything >>> appeared to make >>> correctly. >>> >>> I went to the utilities directory and ran the installmgr >>> >>> sudo ./installmgr -sc //Synch with master appeared to work >>> sudo ./installmgr -r CrossWire //refresh remote source - appears to >>> work, 411 packages >>> sudo ./installmgr -ri CrossWire KJV //returns 'Remote source >>> [CrossWire] does not make available module [KJV] >>> >>> sudo ./installmgr -rl CrossWire //list modules on CrossWire - sure >>> enough, no KJV >>> >>> Went to ~/.sword/InstallMgr/20081216195754/mods.d/ and found kjv.conf. >>> So refreshing the remote source finds KJV but install does not. >>> >>> OK - let's try a local install: >>> >>> Downloaded ESV.zip and unpacked it into the same directory (Downloads) >>> >>> sudo ./installmgr -li ~/Downloads/ESV.zip ESV >>> Module [ESV] not available at path [/home/jsb/Downloads/ESV.zip] >>> >>> sudo ./installmgr -li ~/Downloads/ESV ESV >>> Module [ESV] not available at path [/home/jsb/Downloads/ESV] >>> >>> sudo ./installmgr -li ~/Downloads/ESV/mods.d ESV >>> Module [ESV] not available at path >>> [/home/jsb/Downloads/ESV/mods.d] >>> >>> sudo ./installmgr -li ~/Downloads/ESV/modules ESV >>> Module [ESV] not available at path >>> [/home/jsb/Downloads/ESV/modules] >>> >>> Well, that didn't work. So let's try just extracting the archive into >>> /usr/share/sword >>> >>> cd /usr/share/sword >>> sudo unzip ~/Downloads/ESV.zip >>> Archive: /home/jsb/Downloads/ESV.zip >>> inflating: modules/texts/ztext/esv/nt.bzv >>> inflating: modules/texts/ztext/esv/nt.bzs >>> inflating: modules/texts/ztext/esv/ot.bzs >>> inflating: modules/texts/ztext/esv/nt.bzz >>> inflating: modules/texts/ztext/esv/ot.bzv >>> inflating: modules/texts/ztext/esv/ot.bzz >>> inflating: mods.d/esv.conf >>> >>> That's hopeful, let's try it out. >>> >>> cd ~/sword-1.7.3/examples/cmdline //previously made this >>> project >>> ./lookup ESV Jn.3.16 >>> Could not find module [ESV]. Available modules: >>> >>> Note that the list of available modules is empty. >>> >>> So at this point I'm stuck. It is my hope to write a front end in C#, >>> but I can't seem to get the package installed and working properly. >>> >>> I'd appreciate any help. >>> Jon >>> >>> >>> >>> _______________________________________________ >>> sword-devel mailing list: sword-devel@crosswire.org >>> http://www.crosswire.org/mailman/listinfo/sword-devel >>> Instructions to unsubscribe/change your settings at above page >>> >> >> >> >> _______________________________________________ >> sword-devel mailing list: >> sword-devel@crosswire.orghttp://www.crosswire.org/mailman/listinfo/sword-devel >> Instructions to unsubscribe/change your settings at above page >> >> >> >> _______________________________________________ >> sword-devel mailing list: sword-devel@crosswire.org >> http://www.crosswire.org/mailman/listinfo/sword-devel >> Instructions to unsubscribe/change your settings at above page >> > > > > _______________________________________________ > sword-devel mailing list: > sword-devel@crosswire.orghttp://www.crosswire.org/mailman/listinfo/sword-devel > Instructions to unsubscribe/change your settings at above page > > > > _______________________________________________ > sword-devel mailing list: sword-devel@crosswire.org > http://www.crosswire.org/mailman/listinfo/sword-devel > Instructions to unsubscribe/change your settings at above page >
_______________________________________________ sword-devel mailing list: sword-devel@crosswire.org http://www.crosswire.org/mailman/listinfo/sword-devel Instructions to unsubscribe/change your settings at above page
