Ha, I don't know how many times I looked at that and didn't see it! But
I had presumed it must be something simple (although an error message at
module installation would have helped :-) ).
Is it Sword code or Xiphos code that does the actual installation?
All working now -- I'm now a USFM->Sword module builder :-D
Thanks again,
Robert.
On 01/10/10 22:10, Troy A. Griffitts wrote:
If I remember right, I think you have .modules at the start of your
DataPath. It should be ./modules
On 10/01/2010 09:23 AM, Robert Hunt wrote:
I'm not sure where to look or go back to from here. I didn't seem to get
any errors anywhere along the way but something is still obviously not
quite right.
Thanks,
Robert.
_______________________________________________
sword-devel mailing list: sword-devel@crosswire.org
http://www.crosswire.org/mailman/listinfo/sword-devel
Instructions to unsubscribe/change your settings at above page
