> from Ole Holm Nielsen <[email protected]>:
| You might want to check out my Wiki-page for setting up Slurm on
CentOS
>7.2: https://wiki.fysik.dtu.dk/niflheim/SLURM .
>Perhaps you'll solve the problem using this information? Thank you very much
>for your reply !
I have read your good page again.
It looks by my opinion that you should add to it some your own strings about
adding (in your example)
corresponding SlurmctldLogFile and SlurmdLogFile statements to slurm.conf .
I may now write again that (in my previous message) I wrote about 2 slurm
ERRORS.
Now slurm works on my PC, but in patricular there was no any NETWORK ADDRESS
errors presented by slurm.
I didn't any changes having relations to NETWORK ADDRESSes but slurm now works
OK.
But reading of your site gave me new ideas what may be interesting to do.
Yours
Mikhail
>
>
>On 10/27/2016 04:14 PM, Mikhail Kuzminsky wrote:
>> I worked w/PBS and SGE; now I'm beginner w/slurm, and installed
>> slurm-16.05.5 on my home PC/x86-64 under CentOS 7.2 1511 (desktop
>> installation).
>>
>> 1) Munge isn't necessary for my one PC w/slurm. But
>> (after standard rpmbuild) directory /usr/lib64/slurm don't have
>> auth_none.so plugin,
>> and AuthType=auth/none in slurm.conf can't work, I use AuthType=auth/munge.
>>
>> 2) Both slurmd and slurmctld work on "myhome1" node.
>> But "scontrol show nodes" informs that:
>> ...
>> Reason=NO NETWORK ADDRESS FOUND [slurm@2016-10-16T10:49:05]
>>
>> Therefore any my srun's say
>> srun: Required node not available (down, drained or reserved)
>> srun: job NN queued and waiting for resources
>>
>>
>> I tried 3 variants of NodeName in slurm.conf : w/o NodeAddr and w/use
>> 192.168.1.10 or even 127.0.0.1
>> My current string in slurm.conf is:
>> NodeName=myhome1 Sockets=1 CoresPerSocket=2 ThreadsPerCore=1
>> NodeAddr=192.168.1.10 State=UNKNOWN
>>
>>
>> Statical IP w/192.168.0.10 local address is used on my PC.
>> /etc/hosts is:
>> 127.0.0.1 localhost localhost.localdomain localhost4
>> localhost4.localdomain4
>> ::1 localhost localhost.localdomain localhost6
>> localhost6.localdomain6
>> 192.168.1.10 myhome1.ru myhome1
>>
>> /etc/sysconfig/network-scripts/ifcfg-enp8s0 contains:
>> TYPE="Ethernet"
>> BOOTPROTO="static"
>> NAME="enp8s0"
>> DEVICE="enp8s0"
>> IPADDR="192.168.1.10"
>> GATEWAY="192.168.1.1"
>> DEFROUTE="yes"
>> ONBOOT="yes"
>> PREFIX="24"
>> etc
>>
>> External connection w/global Internet is realized via the same "enp8s0"
>> and home router at 192.168.1.1
>>
>> What should I do to have normal address for myhome1 for work w/slurm ?
Mikhail Kuzminsky
