I recommend that you make all CS with only: Pure steam distilled water, at
least '999 silver wire or ingots and low voltage. Upon completion (about 3
hours) I check for tyndall, pour into storage container, dilute with extra
distilled water if too strong; then add 1 teaspoonful (5cc) H202 per quart.
Leave a couple ounces of original CS in container to give better circulation
in making more.
Best regards,
Richard Harris, 56 yr FL Pharmacist
-----Original Message-----
From: Ode Coyote [mailto:[email protected]]
Sent: Tuesday, October 07, 2003 11:08 AM
To: [email protected]
Subject: Re: CS>RE: Another newcomer
At 05:59 PM 10/6/2003 -0000, you wrote:
>>>>
I am about to make my 3rd batch of cs. Am I supposed to make it with a
lid on the jar? And, there has been mention that the benefits of cs are made
even better with h202. I am using a quart jar. How much hydrogen peroxide
would I put into that amount. And if I've put the h202 in the cs, am I still
able to put some of the mix in the next batch as a starter?
<<<<
NO NO NO NO
Well, OK. I only did that once and it was a disaster.
It turned about half of the electrode into nice big shiny metal flakes and
conductivity never exceeded 13 uS.
Never tried it again.
Ode
>>>>
I am totally confused about the seconds on and off or some such and
figure for now to just stick to the simple stuff. And hope to gleen more as
I go along. Also, do I need a ppm tester? If so, is there a simplified way
of making one?
I would eventually like to make a magnetic pulser for my husbands
prostate cancer. If anyone knows where I can get some directions, it would
be appreciated. Thanks for any and all help. Norma
<<<<
-- The silver-list is a moderated forum for discussion of colloidal
silver.
Instructions for unsubscribing may be found at: http://silverlist.org
To post, address your message to: [email protected]
Silver-list archive: http://escribe.com/health/thesilverlist/index.html
List maintainer: Mike Devour
