25 volts at 50/60 HZ does not impart enough velocity to the ions to get them far enough away from the electrodes to not be sucked back on when the polarity changes. To use that "SWAP" frequency requires around 1000 volts. Minimum at 25 volts would be around 1 minute between polarity shifts and that will be very slow as it takes around 20 seconds out of a cycle for the electrochemistry to unwind and reverse. 3 minutes goes at about the same rate as DC Anything over a few seconds is very difficult using analog timing circuits, longer is harder and less reliable/accurate. That why I finally went digital. A computer can count infinite milliseconds effortlessly and get it right every time with a 5 minute interval. Ode
On Tue, Mar 3, 2015 at 11:13 AM, Reece Maxey <[email protected]> wrote: > Has anyone used a low, ie 25 volts, AC power source for a CS generator? > Any ideas about posslble success if using? Seems to me it would compare > with the swapping DC method. Thanks. > Opa > > Sent from my iPad > > > -- > The Silver List is a moderated forum for discussing Colloidal Silver. > Rules and Instructions: http://www.silverlist.org > > Unsubscribe: > <mailto:[email protected]?subject=unsubscribe> > Archives: > http://www.mail-archive.com/[email protected]/maillist.html > > Off-Topic discussions: <mailto:[email protected]> > List Owner: Mike Devour <mailto:[email protected]> > > >
