John and I were discussing the different cathodes ... (or the metal you can use for the minus end of your circuit) obviously we would need pure silver for the Anode to release itself into the water.. but the other end can be any other metal that is safe to use and will not contaminate your brew in any way. CAVEAT: if you can safely ensure that only your ANODE will be SILVER then .. and only then look to substituting your CATHODE for something else.. I DO NOT RECOMMEND THIS FOR MOST PEOPLE due to the possibility of human error... I my case I've made it idiot proof and isn't even possible to make that error....
also the vessel you use can make a difference as the lead in glass can leach into the brew so one should be careful in choosing the vessel. if unclear let me know. I'm sure others here are considerably more proficient in answering any questions than myself. Peace to All. Asif. From: Ron Sent: Monday, August 25, 2014 12:33 AM To: [email protected] Subject: Re: CS>Two Important Questions John I sure don't understand a bit of it. Ron On 8/24/2014 2:33 PM, Rusty wrote: I’m sorry but I don’t know your name. The link that John sent me sounded possible to do…but what you’re saying to me is like Greek…it sounds so complicated. I don’t know whether to try to go ahead if it is this complicated. Kathleen From: asifnathekar [mailto:[email protected]] Sent: August 19, 2014 9:22 AM To: [email protected] Subject: Re: CS>Two Important Questions John I use stainless steel so that it wont leach anything into the water Even the vessel is borosilicate glass as some of us found that regular glass could leach its materials such as lead. For me it made a difference. As for the polarity I have made it idiot proof.. If one required pulsing and a non silver cathode then dc only pulses would be required. . Im guessing your using AC for your design ...... to keep thr electrodes clean. I just swap out my stainless steel plates for the spare pair so that the stuff accumalates on a clean cathode and not fall down into the water where it would contaminate the brew Sent from Samsung Mobile -------- Original message -------- From: John Popelish <[email protected]> Date: 19/08/2014 13:47 (GMT+00:00) To: [email protected] Subject: Re: CS>Two Important Questions John On 08/19/2014 04:22 AM, asifnathekar wrote: > John > I use stainless steel sheets for my cathodes > Since theyre not emitting anything they are fine for this purpose. ... I have tried the carbon rod, from the center of a carbon-zinc battery, but it got plated with silver so I reversed the connections, occasionally, to unplate them. After that, I just use similar silver electrodes, so I can reverse the current, periodically, to cut the rate of silver loss from either, in half. I think, with a stainless steel electrode, you have to be careful of polarity and use strictly DC to drive the process, or you risk getting iron, nickel, chromium, manganese etc. in the solution. With two silver electrodes, this cannot happen, regardless of current direction. -- Regards, John Popelish -- The Silver List is a moderated forum for discussing Colloidal Silver. Rules and Instructions: http://www.silverlist.org Unsubscribe: <mailto:[email protected]?subject=unsubscribe> Archives: http://www.mail-archive.com/[email protected]/maillist.html Off-Topic discussions: <mailto:[email protected]> List Owner: Mike Devour <mailto:[email protected]> -------------------------------------------------------------------------------- This email is free from viruses and malware because avast! Antivirus protection is active.
