Re: [WiX-users] First run notepad with my.cfg and only then start the service

e the config file. When the install runs silently these > properties can be set on the msiexec command line. > > Phil Wilson > > -Original Message- > From: Viv Coco [mailto:vcotirl...@hotmail.com] > Sent: Tuesday, April 06, 2010 1:29 AM > To: General discussion

Re: [WiX-users] First run notepad with my.cfg and only then start the service

XML toolset. Subject: Re: [WiX-users] First run notepad with my.cfg and only then start the service I actually thought about doing it like this: [code] Notepad.exe (NOT Installed) AND (NOT UPGRADINGPRODUCTCODE) [/code] This seems to be doing the job. Is this not correct? Thx, Viv On 4/3/

Re: [WiX-users] First run notepad with my.cfg and only then start the service

I actually thought about doing it like this: [code] Notepad.exe (NOT Installed) AND (NOT UPGRADINGPRODUCTCODE) [/code] This seems to be doing the job. Is this not correct? Thx, Viv On 4/3/2010 3:20 PM, Bob Arnson wrote: > On 4/1/2010 9:28 AM, Viv Coco wrote: > >> shown to the user to mo

Re: [WiX-users] First run notepad with my.cfg and only then start the service

On 4/1/2010 9:28 AM, Viv Coco wrote: > shown to the user to modify as needed (I give the user the chance to > change it by running notepad.exe with my conf file during installing) > You can't run UI during InstallExecuteSequence. You should let the user configure after installation. -- sig:/