Hi Marcus,
I am looking at the following link
https://files.ettus.com/schematics/x300/x3xx.pdf
and as you said same clock is being used by both the boards. NI has asked for
some time to find it out.
Regards,
Koyel
From: Koyel Das (Vehere)
Sent: Monday, S
I had a system that worked pretty well for creating a new bitfile for my E310.
I ran through all the steps again so I could make sure that my notes were OK,
but now I get an error when I run a probe on my E310 using that bitfile.
I copied over the bitfile and replaced
/home/root/localinstall/
Hi Michael,
Were these issues resolved in a recent commit (included in 3.13.0.3 RC)?
Rob
On Thu, Sep 6, 2018 at 2:12 PM Michael West wrote:
> Update: The issue is included on the head of the UHD-3.12 branch, but is
> not included in the v3.12.0.0 release. So, be sure to checkout the
> v3.12.0.
On 09/17/2018 02:42 AM, Koyel Das (Vehere) wrote:
Hi,
I don't have a splitter currently. So to use it I need to wait until
it arrives.
I din't find uhd_fft in gnuradio. I am using gnuradio-companion.
However, I see similar issues faced by some other people:
https://lists.gnu.org/archiv
On 09/17/2018 06:31 AM, Koyel Das (Vehere) wrote:
Hi Marcus,
I am looking at the following link
https://files.ettus.com/schematics/x300/x3xx.pdf
and as you said same clock is being used by both the boards. NI has
asked for some time to find it out.
Regards,
Koyel
You might try disab
Hi Marcus,
My colleague suggested not to use TX/RX port and I did that. I just tested two
sets of data of stationary wifi with both antennas this time connected to RX2
port as he suggested and then the phase difference deviation goes maximum to
0.3 rad. I will carry out experiments with more da
Hey everybody,
Is there anywhere I could find C++ examples of a TX stream using RFNoC
blocks? The latest rnoc-devel commit only has two RX examples, and I cannot
seem to replicate the behavior from that.
Thanks,
Leo
___
USRP-users mailing list
USRP-use
Martin,
I can only find methods to write the user registers, poke32() and
set_user_register() using the less invasive access method. Is there a
peek32() or get_user_register() method to read custom registers in the
user_regs address space?
Thanks,
Mark
_
Hi Marcus,
yesterday I got the deviations of 0.3 rad by fluke. Even after receiving using
two RX2 ports the phase difference is deviating to large values like 2 rad. I
tried disabling I/Q corrections by passing 0 to the property field but that
too didn't work. I think I really now need to use
