That is correct, and that will also allow you to run said example.
-- Martin
On Thu, Jan 10, 2019 at 10:27 AM Xingjian Chen via USRP-users <
usrp-users@lists.ettus.com> wrote:
> It works by setting tx-blockid to 0/Radio_0 and tx-chan to 1. I think
> there is only one radio in E312 but two chann
Emanuel,
the TwinRX only works with 200e6 clock rate. The analog filtering is not
designed for other rates. So if you have even one TwinRX, you need 200e6.
I'll make sure we update our manual to clarify that.
-- M
On Fri, Jan 11, 2019 at 4:51 AM Emanuel via USRP-users <
usrp-users@lists.ettus.co
Varala,
you only need to add a logging backend if you want the log message to go
somewhere other than stderr or a log file.
The 'console logger' means 'stderr'. So, just grab your stderr output if
you want to have those log messages. You can control the console log level
with the UHD_LOG_LEVEL an
On 01/11/2019 09:58 AM, Daniel Jepson wrote:
Hi Kwansik,
The Octoclock datasheet specification is only valid when driving into
a 50 ohm load, and it should be just under 1.4Vpp.
Cheers,
-Daniel
Indeed, which is why the oscilloscope trace shows a bit of distortion--I
see the exact same thing
On 01/11/2019 10:42 AM, Yang Liu wrote:
Hi Marcus,
I have one more question, SBX and UBX support phase alignment (phase
synchronization) on certain usrps. Does phase alignment means that
after using timed commands, the phase offset between two front-ends
will be always zero (or very close to
Hi Marcus,
I have one more question, SBX and UBX support phase alignment (phase
synchronization) on certain usrps. Does phase alignment means that after
using timed commands, the phase offset between two front-ends will be
always zero (or very close to zero) or just be a constant which doesn't
var
Hi Kwansik,
The Octoclock datasheet specification is only valid when driving into a 50
ohm load, and it should be just under 1.4Vpp.
Cheers,
-Daniel
On Thu, Jan 10, 2019 at 7:22 PM Marcus D. Leech via USRP-users <
usrp-users@lists.ettus.com> wrote:
> On 01/10/2019 08:07 PM, Kwansik Park via USR
Dear Ettus team,
we have a configuration of an X310 with one TwinRX and one CBX-120 front-end.
uhd_usrp_probe shows both front-ends correctly. The latest UHD release is used.
Now if I want to use, e.g., benchmark_rate or an application in Gnuradio, I get
the following warnings:
* Not se
