Hi Tim!
BTW: Thanks for all your work on this. Great work and really appreciated.
Just a quick note:
On 24.04.2014 10:06, Tim Harvey wrote:
If I were to split the partitions like the above change, it will cause
some grief for existing users that are using the 3.0.35 (non
device-tree) vendor
Hi Tim,
On 24/04/2014 10:06, Tim Harvey wrote:
>>> +
>>> +/* configure mx6 mmdc io registers */
>>> +struct mx6_mmdc_ioregs mmdc_ioregs = {
>>> + /* DDR3 */
>>> + .mmdc_grp_ddr_type = 0x000c,
>>> + /* disable DDR pullups */
>>> + .mmdc_grp_ddrpke = 0x,
>>> + /* SDCL
On Wed, Apr 23, 2014 at 11:03 AM, Stefano Babic wrote:
> Hi Tim,
Hi Stefano,
>
> On 03/04/2014 08:01, Tim Harvey wrote:
>> Switch to an SPL image. The SPL for Ventana does the following:
>> - setup i2c and read the factory programmed EEPROM to obtain DRAM config
>>and model for board-specif
Hi Tim,
On 03/04/2014 08:01, Tim Harvey wrote:
> Switch to an SPL image. The SPL for Ventana does the following:
> - setup i2c and read the factory programmed EEPROM to obtain DRAM config
>and model for board-specific calibration data
> - configure DRAM per CPU/size/layout/devices/calibratio
On Wed, Apr 2, 2014 at 11:01 PM, Tim Harvey wrote:
> Switch to an SPL image. The SPL for Ventana does the following:
> - setup i2c and read the factory programmed EEPROM to obtain DRAM config
>and model for board-specific calibration data
> - configure DRAM per CPU/size/layout/devices/calibr
Switch to an SPL image. The SPL for Ventana does the following:
- setup i2c and read the factory programmed EEPROM to obtain DRAM config
and model for board-specific calibration data
- configure DRAM per CPU/size/layout/devices/calibration
- load u-boot.img from NAND and jump to it
This allo
6 matches
Mail list logo
