Hi,
I am using u-boot-2015.01 loader on MPC8641D based Board. I have following
queries Related to PCIe bus
1. Does it provide support to pcie switch(PES64H16AG2) support?
2. Do I need any specific driver for this switch to make it up?
After booting its not showing any link the logs are:
U-Boot 2
>
> On 03/19/2015 08:12 AM, Ashish Khetan wrote:
>
>> Hi All,
>> I have been facing a strange problem in my board which is MPC8641D based.
>> In this board we have two nor spansion flashes connected to cs0 and cs1. U
>> boot had detected both the flashes and when flin
is
crashing.
Flash part no is s29gl01gs which is CFI complaint.
Please provide some pointers where I should concentrate more to resolve
this issue. As I have checked all the configuration in configuration file
it seems to be fine. Any help will be really appreciated.
Ashish Khetan
+91-8886013575
gt; BTW: i am using a stripped image which i directly start with "go
> ", but that shouldn't matter.
>
> best regards,
> Hannes
>
>
>
> On 2014-09-09 03:56, Ashish Khetan wrote:
>
>> Hi Hannes
>> Thanks for your reply. I am using VxWorks 6.7 and the
peterma...@br-automation.com> wrote:
> Hi Ashish,
>
> i had a problem booting vxworks in the past around interrupt vectors.
> Which version of vxworks you are using ? do you use a stripped image ?
> is the loadaddress the same within kernel configuration ?
>
> best regard
Hi,
I was trying to boot vxworks using u-boot bootloader for learning purpose
on MPC8640DHPCN board. Previously I successfully ported QNX os along with
linux on same board using u-boot. while booting using bootvx command its
not booting and stucking after showing the following message:
tftp 01
Hi,
I am a little bit confused about u-boot smp and u-boot asmp on mpc8641d
based HPCN board. when i am enable config_mp, in which mode it boots? In
SMP u-boot or ASMP u-boot? and if it boots in smp mode then how am i going
to boot ASMP linux?
Please show me some way to boot ASMP linux . Any point
o get more
understanding for this... I am getting frusted because I am stuck at this
point from last 20 days. please help... thanks in advance and Regards
On Sat, Oct 26, 2013 at 12:20 AM, Ashish Khetan wrote:
> Thanks For reply, i check DDR configuration using Code warrior, and
> successfu
You can
> try to dump all DDR registers and check if anyone is suspicious. You can
> also override any register before enabling the controller.
>
> You may also add some memory test before relocation.
>
> York
>
> On 10/25/2013 06:38 AM, Ashish Khetan wrote:
> > hii I am
hii I am using MPC8641D based custom board for evaluation purpose. I am
using minimal configuration for this board i.e. only FLASH and DDR
initialisation. when I compiled U-boot in debug mode its printing
addresses, i check for those addresses and found that it is unable to
relocate itself to DDR(4
10 matches
Mail list logo
