Thanks, Jim. I like that approach.
On Jul 1, 3:26 am, CycloFiend wrote:
> on 6/29/09 3:22 PM, R Gonet at richard.go...@earthlink.net wrote:
>
>
>
> > I've installed SKS fenders on my Quickbeam and now I have to detach
> > the rear fender stays to remove the rear wheel, either to reverse the
> >
on 6/29/09 3:22 PM, R Gonet at richard.go...@earthlink.net wrote:
>
> I've installed SKS fenders on my Quickbeam and now I have to detach
> the rear fender stays to remove the rear wheel, either to reverse the
> wheel or to fix a flat. Is there any way around having to do this
> and, if not, do
well, I'm going to go against convention here and recommend
taking the fenders off. I managed to figure out how to drop the
rear wheel to fix a flat, but I'm sticking with a fenderless QB.
it was a liberating experience, and I'm thinking of removing the
fenders from my atlantis now.
best
ts
On
On Jun 29, 11:57 pm, R Gonet wrote:
> Jay: I like that idea. Have you actually tried it? I'm wondering if
> you can pull the fender up and back enough to release the wheel, given
> that the fender is attached to the seat stay bridge.
Yep. Works just fine. It's hard to beat those SKS fender
I did the "quick release clips" thing like Jay.
http://www.flickr.com/photos/16951...@n08/3476231554/sizes/o/
I have removed the rear wheel (most recently to add a fixed cog) by
unclipping the fender stays from the quick release clips. When the
chain is in the small chainring, the axle is at th
Jay: I like that idea. Have you actually tried it? I'm wondering if
you can pull the fender up and back enough to release the wheel, given
that the fender is attached to the seat stay bridge.
On Jun 29, 9:13 pm, "J. Burkhalter" wrote:
> Round up another pair of the black plastic quick release
Round up another pair of the black plastic quick release clips that
came with the SKS fender set (the ones intended for use on the front
fender stays). They'll allow you to pop the rear stays out and remove
the wheel. RBW probably has them, but you could try your LBS
first.
hope this helps,
-J
If you're using Phil hubs, you should be able to remove the axle nuts
all the way, in which case the wheel will drop straight down. Not
sure about the stock hubs.
--Eric
campyonly...@me.com
www.campyonly.com
www.wheelsnorth.org
On Jun 29, 2009, at 3:22 PM, R Gonet wrote:
>
> I've install
The key is to leave enough room on the rear stays to be able to loosen
the fender and slide it back. This works best with plastic or wood
fenders. Others will have to chime in on metal fenders, as I've seen
a few alum & steel clad Quickbeams out in the wild. I have plastic &
wood for the QB:
h
