Hi Hauke,
I will modify it and send updated patch.
Which hardware are you using ?
Regards,
Tathagata
On 12.01.2012 03:41, Hauke Mehrtens wrote:
On 01/10/2012 01:00 PM, Tathagata Das wrote:
Hi,
Attached is the updated kernel patch to support brcm47xx BCMA NAND
flash. This patch uses driver/mt
For comedy value, I enabled preemption in my G300NH build:
124.49] BUG: scheduling while atomic: swconfig/811/0x0002
[ 124.50] 2 locks held by swconfig/811:
[ 124.50] #0: (genl_mutex){+.+...}, at: [<8021cd20>] genl_rcv+0x14/0x34
[ 124.51] #1: (&(&dev->lock)->rlock){+
On 11 January 2012 10:55, Helmut Schaa wrote:
> On Tue, Jan 10, 2012 at 11:06 PM, Roman Yeryomin
> wrote:
>> I just faced the same issue - changing HT20 to HT40+/- doesn't give
>> anything but this error:
>>
>> 20/40 MHz operation not permitted on channel pri=1 sec=5 based on
>> overlapping BSSe
On 01/10/2012 01:00 PM, Tathagata Das wrote:
> Hi,
> Attached is the updated kernel patch to support brcm47xx BCMA NAND
> flash. This patch uses driver/mtd/nand/nand_base.c. I have used latest
> trunk source code to create this patch.
>
> Regards,
> Tathagata
Hi Tathagata,
your patch causes my
This patches makes a G300NH version of u-boot, heavily based upon the
existing Zyxel NGB460 code. This is sufficient to be able to kexec
into (or whatever) then access flash, then boot from there back into
Linux. (See previous threads on kexec).
I know that the flash setup isn't exactly right,
Dave Taht wrote:
> [PATCH 4/4] Add local mac support to wndr3700 so as to be able to
> route not bridge
>
> The wndr3700 at least has no eth0 mac address and usually leverages
> the first wireless device's mac when in a bridged scenario. If,
> however, you want to route, and not bridge the interfac
We had some build problems on different platforms recently.
This seemed to resolve them:
gcc pr 41818
build errors where the host and target libraries get mixed up, during
bootstrap
see http://gcc.gnu.org/bugzilla/show_bug.cgi?id=41818
Conor
On Wed, 2012-01-11 at 00:21 +0200, Roman Yeryomin
On Tue, Jan 10, 2012 at 11:06 PM, Roman Yeryomin wrote:
> I just faced the same issue - changing HT20 to HT40+/- doesn't give
> anything but this error:
>
> 20/40 MHz operation not permitted on channel pri=1 sec=5 based on
> overlapping BSSes
>
> This message appears whenever which channel I use i
