Hi Rene,
I have done some time measurements. These are my boot times:
After Powerup:
Bootrom starts after 0 seconds
AT91 boot starts after 0 seconds
u-boot starts after 1 second
linux starts after 7 seconds
linux is ready after 14 seconds
network is up and ubifs is ready after 19 seconds
All tim
I will post it when I am done.
I now realise that this is not so simple, because it might be necessary
to write a device driver for the NAND controller.
So may be it will take a while
Cheers,
Ferdinand
Øyvind Harboe schreef:
> Please post the script to the list so it can be included in the
R.Doss schreef:
> Hallo,
>
> I have also a AT91SAM9260 board.
>
Wich board do you have
> I have found out a strange behaviour.
>
> case 1:
> When the flash is empty it works fine. No problem.
>
> case 2:
> When the board is configured to boot u-boot from parallel Flash. I get
> also errors and
Hallo,
I have also a AT91SAM9260 board.
I have found out a strange behaviour.
case 1:
When the flash is empty it works fine. No problem.
case 2:
When the board is configured to boot u-boot from parallel Flash. I get
also errors and the reset script does not work.
In the reset script is the con
Hi Paul,
The software first tells you it found a device with id-code 0xf074203f. Then it
tries to tell you that an error has occured. The error is split up into 2
lines. Firt it less you wat it got and then it tells you what it had expected.
I also have a board with an at91sam9260 chip. This one
hello,
I'm trying to use openocd on our at91sam9260 board. This board works
fine and a colleague has been using the j-link with the Segger
software just fine. The output from starting is below. It looks like
it's doing something, when I run it without the board connected I get
"Error: JTAG communi
