Hey Guys,It has been a slow week here on the net (unless I got booted from the
club and just don't know it yet). Any way I got a couple hours in this morning
flyin a big triangle around eastern PA. I need to go back out this evening for
a couple circuits around the pattern and I should end the d
I have a set of KR2S plans and the fuselage sides already built. The two sides
are sitting in St. Louis if you want them as well. (or know anyone who would).
I moved to Tampa and didn't bring them.
Sent from my iPhone
On Mar 11, 2012, at 2:56 PM, Glenn Gmail wrote:
> Looking for a set o
Looking for a set of KR1 plans. Anyone have a set of KR1 plans (w serial
number) which they are not going to use and want to sell?
--
Glenn Martin,
KR2 N1333A,
Biloxi, MS
After checking his installation photos, Dan has the accelerometer mounted 90
degrees from the orientation shown in the manual, so the Dynavibe is going
to tell him to put the weights 90 degrees from where they really need to go.
Yep, that could be confusing...
Mark Langford
ML at N56ML.com
webs
Thanks, track is perfect and I have done all that.
I am sure Dynavibe will get with me about it.
See N64KR at http://KRBuilder.org - Then click on the pics
See you at the 2012 - KR Gathering in Mt. Vernon, Il MVN 40th
Anniversary
There is a time for building and it is over.
Daniel R. Heath -
At 06:14 PM 3/9/2012, you wrote:
>I want to know what side load (thrust) a bellcrank bearing can take?.
Peter Leonard
+
I only saw one reply to you question so I'll offer my "opinion".
I don't think the bellcrank bearings should have any
Just a couple of thoughts which I hope may help: Rule #1 for balancing
anything: Check the track before you start anything. Place something on the
ground and line up with the prop tip and then rotate the prop through to see
that the other tip(s) are tracking the same. There may be a slight varia
Dan
I used the Dynavibe once and if I remember correctly you have to place the
balance weights 180 out according to how the accelerometer is installe d.
Jack Cooper
- Original Message -
From: "Dan Heath"
To: "KRnet"
Sent: Sunday, March 11, 2012 7:33:02 AM
Subject: KR> Still
I spent most of today continuing the effort to balance my engine, and so
far, nothing has worked. The results are nothing but confusing. I
contacted Dynavibe and they told me what to do, which did clarify things,
but still no results. I degreed the spinner bulkhead plate and put blind
nuts every
9 matches
Mail list logo
