hi folks back on the list again and i am after vw 2180 parts or a complete
engine
ign system
exhausts
crank
just e mail me pjb1234...@yahoo.co.uk
many thanks
phill
Don't laugh too hard at my naiveté. I enjoy hearing your stories so much I
thought I would add my own for the beginners out there. It is finally cooled
down to the eighties here (at midnight) because of the storm sweeping through.
I was laying up some thick micro on the foam boards of the Hstab
Thanks Dene.
My fax is 015 781 6173
Also thanks to Erric Pitts and Ed that replied.
Regards
- Original Message -
From: "Dene Collett"
To: "KRnet"
Sent: Thursday, September 03, 2009 9:58 PM
Subject: Re: KR> Wiring diagram for King KT76 transponder wanted
Hi Willie I have the drawing...
At 08:35 PM 9/5/2009, you wrote:
>When and where is the Sept. 09 gathering??? Bob Wiehe
>Robert Wiehe
+++
The KR Gathering is Sept 18 and 19 at Mt.Vernon, Illionis
see www.krgathering.org for all the details
Larry Flesner
When and where is the Sept. 09 gathering??? Bob Wiehe
- Original Message -
From:
To:
Sent: Wednesday, September 02, 2009 11:00 PM
Subject: KRnet Digest, Vol 351, Issue 254
> Send KRnet mailing list submissions to
> kr...@mylist.net
>
> To subscribe or unsubscribe via the World Wide
Jeff , et all,
I just lastr weekend did this. I had installed a bung last spring when I built
all stainless steel headers into each side and wired a probe from each side. I
only wired in the switch this past weekend and have only one hour of flight
time on the rig. The results are good so far b
Hi Willie I have the drawing you are looking for. Give me your fax number
and I will fax it to you.
Regards
Dene Collett
Avlec Projects cc
Port Elizabeth
South Africa
- Original Message -
From: "Willie van der Walt"
To: "KRnet"
Sent: Thursday, September 03, 2009 6:48 AM
Subject: KR> Wi
Thinking in terms of an installation on my O-200, I have 4 separate tuned
length exhaust pipes. Knowing that the intake doesn't feed all cylinders
evenly and that the mixtures vary significantly based on throttle setting,
would a mixture meter require 4 separate probes, or 4 separate mixture me
Are the mixture meters the problem or the probe? How long will the meters
last? and how long will the probes last?
Thanks
Larry H.
--
Larry,
The mixture meter is a solid-state panel-mounted unit and should work for
several thousand hours. The probe screws into a bung
> I am looking for a wiring diagram for a King KT76 transponder. >
>
Try this link http://www.aeroelectric.com/Installation_Data/KT76-78.pdf
--
Eric Pitts
Terre Haute Ind.
http://eric.pitts.mystarband.net
"Life should NOT be a journey to the grave with the intention of arriving
safely in an at
10 matches
Mail list logo
