Hello,
I posted a WTB at QTH.com because I needed a KXAT3 tuner module for my
newly acquired KX3. I have received three replies, but they all have too
many red flags. They refused to use PayPal and wanted me to send money to
their wife or daughter's Zelle account. Huh.
Please don't fall for it if
"You are correct. I have made that change in draft 13. "
Turns out that I had corrected that error years ago but I had not linked the
current version of the file.
Here is Rev a - https://tinyurl.com/yzdp7m3m
Andy, k3wyc
__
Elecra
Andy ...
I can't speak to Kenwood interfacing, but I can report that my BigIR
flawlessly follows my K4 as I tune.
My SDA100 is sn12753, which I acquired along with the BigIR in August of
2022.
My connection is the simple RS232 to RS232 cable, controller to radio.
73
Dick, K5AND
-Original Mes
"My question is exactly where to connect the SteppIR control box to the radio."
The simple answer is do not connect that way. The direct SteppIR interface
with a Kenwood/Elecraft rig is very poorly implemented and may cause the
SteppIR to tune at beginning and end of transmission.
Far better t
"I could be wrong, but I think in the second sentence in the second paragraph
under *SDA 100 Kenwood Interface*, the word "not" should be added between does
and match."
You are correct. I have made that change in draft 13.
"The IF command, and the expected response, are described in the Kenwoo
I could be wrong, but I think in the second sentence in the second paragraph
under *SDA 100 Kenwood Interface*, the word "not" should be added between does
and match.
Wes N7WS
On 3/15/2025 6:35 AM, Andy Durbin wrote:
"My question is exactly where to connect the SteppIR control box to the rad
"I can't speak to Kenwood interfacing, but I can report that my BigIR
flawlessly follows my K4 as I tune."
Since I renewed my interest in amateur radio about 12 years ago I have been
told several times that my reports of firmware/software/system defects were not
valid. I learned than most peo
Good Evening,
It has been a snowy, wet week. Gray too. The sun has a good number
of sunspots but they are stable. No CMEs on the way. There is strong
flux. I expect some noise but lower QSB than we have had lately.
Conditions could be OK to good. Let's find out tomorrow.
Please joi
This issue has been present with SteppIR controllers for
all of their antennas and Kenwood transceivers since the
very beginning and is not likely to *ever* be fixed due
to limitations in the Kenwood IF (autoinformation)
"broadcast". 1) IF contains the current operating frequency
and changes be
9 matches
Mail list logo
