Hi Hew How Chee,
Hew How Chee wrote:
Hi Martin,
Pretty good hacking you have done there. Maybe I'll
try it one day, after the warranty expires :)
I think I am going to look for a nice cx2388x
capture card.
What card are you using ?
What tuner is on it? (Is it easy to hack?)
I am using Pi
Hello All,
It seems like something may have broken in the 3Dnow fir code (on Debian Unstable), it may be
GNURadio or it may be GCC. Has anybody seen this?
SSE seems to be faster on this processor anyways, is there a recommended way of selecting SSE over
3Dnow! ?
Some information below
**
Martin Dvh wrote:
> I think I mixed up pin 2 and pin 5 of the transformers in my last mail.
> (I do not find it intuitive to put the middle lead of a winding on the
> other side of the component.)
>
> (pin 2 should be connected to gnd and pin 5 shouldn't)
> Although information on the internet con
The output side of the transformer is not center tapped. The input side
is. The input side center tap needs to connect to ground. On the
ADT1-1WT and the ADT4-1T the center taps are on pins 2 and 5
respectively. That's why I connect both -- so that you could switch to
the other transformer i
I think I mixed up pin 2 and pin 5 of the transformers in my last mail.
(I do not find it intuitive to put the middle lead of a winding on the other
side of the component.)
(pin 2 should be connected to gnd and pin 5 shouldn't)
Although information on the internet contradicts.
The datasheet says
Hi all,
>Eric Blossom wrote:
On Fri, Aug 19, 2005 at 02:56:53AM +0200, Martin Dvh wrote:
Hi,
What output voltage level should I expect from the basic tx?
The docs say it delivers maximum 20 mA into 25 or 50 ohm.
At 50 ohm this should result in 1.0 V max.
The most I can get out of it is 50 mV
T
2005 ARRL/TAPR Digital Communications Conference
September 23-25, 2005
Santa Ana, California
http://www.tapr.org/dcc
Make Your Hotel Reservations Now! DCC Hotel Rates end Aug. 31st
-
Time is drawing nearer to the Digital Communicat
It looks like something like this is possible in newer wx releases.
I haven't tested it yet, though...
import wxversion
wxversion.select('2.6')
--
Ramakrishnan http://www.hackGNU.org/
Use Free Software -- Help stamp out Software Hoarding!
