Re: Stus-List Surveyors.

Used this gent twice. James M. Dias – NAMS® Certified Marine Surveyor Accredited Marine Surveyors One Dock Lane Guilford, CT, 06437, USA Toll Free: Land Line: (203) 901-5235 Sent from my iPhone > On Jun 13, 2019, at 1:06 PM, Brien Sadler via CnC-List > wrote: > > Because I trust the opinions

Re: Stus-List Worn stanchion base sockets

FWIW my stanchions come off in the fall to put the winter cover on and when I was putting them back on I noticed there were two holes for the set screw and a big dollop of what seemed like the sealant they used to seal the hull and deck, in the bases. I pulled out the sealant and the stanchions

Stus-List Engine clean-up

Parts of my Beta 28 diesel engine have serious paint/rust scaling issues that I would like to remove before cleaning and spray painting the engine. Unfortunately, most of this is in/around the front of the engine (forward facing) cooling lines, alternator, etc. which is impossible to reach with

Stus-List Jib Halyard Length for a 37+?

Listers, My jib halyard is snapped. Anyone know offhand the width and length for a replacement? I think it 7/16 x 150, but not sure. All the best, Edd ---—--- Edd M. Schillay Captain of the “Starship Enterprise” C&C 37+ | Sail No: NCC-1701-B City Island Yacht Club

Re: Stus-List Jib Halyard Length for a 37+?

120' of 7/16" Braided Dacron (actually, the original was probably 53' of 3/16" S. S. wire spliced to 66' of 7/16" Braided Dacron, see the Owner's Manual, Table 3 near the end, Pg. 66?). 150' will certainly give you some extra to play with. Ken H. On Sat, 15 Jun 2019 at 16:02, Edd Schillay via

Re: Stus-List Worn stanchion base sockets

Silly question which is Height and width I assume 1 7/8 H , tall but the 3 “ would wrap several time around and hope do you then notch for set screw? Wrap 1st have 1 or 2 that are possible candidates:) Thanks again! John Conklin S/V Halcyon > On Jun 15, 2019, at 12:01 PM, T Sutton via CnC-L

Re: Stus-List Jib Halyard Length for a 37+?

I can't help you with the dimensions, but I’d suggest to talk to our local expert, Chuck, on the rope type, _before_ you buy. My choice was Novabraid XLE Performer. Marek 1994 C270 Legato Ottawa, ON Sent from Mail for Windows 10 _

Re: Stus-List Worn stanchion base sockets

A one inch diameter stanchion has a circumference of about three inches (pi x d). I notched the open ends 1/8 inch or so, about half way up, something like this: ___ |_ _| |_| so when the plastic is bent around and inserted into the socket, there's an