Silly question which is Height and width I assume 1 7/8 H , tall but the 3 “ would wrap several time around and hope do you then notch for set screw? Wrap 1st have 1 or 2 that are possible candidates:) Thanks again!
John Conklin S/V Halcyon > On Jun 15, 2019, at 12:01 PM, T Sutton via CnC-List <cnc-list@cnc-list.com> > wrote: > > FWIW my stanchions come off in the fall to put the winter cover on and when I > was putting them back on I noticed there were two holes for the set screw and > a big dollop of what seemed like the sealant they used to seal the hull and > deck, in the bases. I pulled out the sealant and the stanchions would sink a > little deeper in the base and the set screw now goes into the upper hole. > The stanchions are much more solid in the bases but oddly the life lines are > much tighter now. It's almost like they raised the stanchions a centimeter > or so to make the life lines fit better. Hmmm.... > > Tom S > > C&C 33 Mk II K/CB > Port Elgin, ON > > -----Original Message----- From: Adrian Humphreys via CnC-List > Sent: Thursday, June 13, 2019 6:16 PM > To: cnc-list@cnc-list.com > Cc: Adrian Humphreys > Subject: Re: Stus-List Worn stanchion base sockets > > I followed Mike and Bill's advice. > > 85 cents for a 2 litre bottle of soda pop, > poured out the beverage, > cut the bottle into 1-7/8 x 3 inch strips (notched for the set screw), > sleeved the sockets (lubed with dish soap), > replaced the stanchions. > > Eh voila! > > Stanchions are tight and the admiral feels safe again. > > Thanks! > > Adrian Humphreys > Epilogue, Rockport ME > C&C 33-2 > adri...@telamontech.com > > > > >> On Apr 2, 2019, at 9:47 AM, Adrian Humphreys via CnC-List >> <cnc-list@cnc-list.com> wrote: >> >> The stanchions are loose in the worn sockets of the plastic stanchion bases. >> >> Before I order eight new ones, I'm wondering if anyone has tried filling the >> socket with epoxy and either setting the stanchion in the wet epoxy, or >> letting the epoxy set and re-drilling for the stanchion? >> >> Thanks, >> >> Adrian Humphreys >> Epilogue, Rockport ME >> C&C 33-2 >> adri...@telamontech.com >> >> >> >> >> >> _______________________________________________ >> >> Thanks everyone for supporting this list with your contributions. Each and >> every one is greatly appreciated. If you want to support the list - use >> PayPal to send contribution -- https://www.paypal.me/stumurray >> > > > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each and > every one is greatly appreciated. If you want to support the list - use > PayPal to send contribution -- https://www.paypal.me/stumurray > > _______________________________________________ > > Thanks everyone for supporting this list with your contributions. Each and > every one is greatly appreciated. If you want to support the list - use > PayPal to send contribution -- https://www.paypal.me/stumurray > _______________________________________________ Thanks everyone for supporting this list with your contributions. Each and every one is greatly appreciated. If you want to support the list - use PayPal to send contribution -- https://www.paypal.me/stumurray
