Re: Stus-List boom

I’ve had the same problem, which prevented sleep in a rolly anchorage. A simple solution was to sheet the boom fairly tight, then use a short length of 3/8 inch line to pull the end of the boom over toward one side, in my case, to a jam cleat near the main jib sheet winch. This is part of my

Re: Stus-List PNW Rondezveous

We had thought about going, although it’s a pretty long haul from Anacortes for a weekend. If I can get some time away from work, we’ll be there. Mike S/V Limerick 1989 CC 30-2 Anacortes WA From: Tom Buscaglia [mailto:t...@sv-alera.com] Sent: Thursday, July 09, 2015 7:43 AM To: cnc-list@cnc-lis

Re: Stus-List Indigo 3 blade propeller

I recently owned a Ranger 29 that had the Indigo prop powered by an A-4. It was great, drove the boat well, never had any problems. Mike From: tim [mailto:hobie1...@comcast.net] Sent: Wednesday, May 13, 2015 7:42 PM To: cnc-list@cnc-list.com Subject: Stus-List Indigo 3 blade propeller Hi, I

Re: Stus-List Anchor locker latch for C&C 30-2

Thanks Kevin. Your reply pointed me in the right direction. I think it’s the Perko latch at this link: http://www.perko.com/catalog/locks_and_latches/113/flush_lock_&_latch_with_2_keys/ Don’t know if I need the locking capability, but this one fits so I’ll probably go with it. Thanks again, M

Stus-List Anchor locker latch for C&C 30-2

Does anyone know where to get a replacement anchor locker latch for a C&C 30-2? My wife and I were pulling into an anchorage this past weekend and when I went forward to get the anchor ready I found that the tab on the latch was missing... don't know where it could have gone, but the result was

Stus-List fishing radar cables through C&C 30-II headliner

Has anyone on the list had any experience fishing wires through the headliner of a C&C 30 mark II? I just added a radome on my mast with the cables exiting the mast along with the masthead light, etc, wiring and I'd like to get them back to the panel without going through the bilge. Thanks in a

Re: Stus-List Sealant or adhesive?

I just removed and resealed the skylight in my C&C30 MK II this past summer with Sikaflex, and yes you must use their primer. But make sure you wear rubber gloves and protect everything from spillage or else you will have black stuff EVERYWHERE that doesn't come off. My hands had traces of tha

Re: Stus-List Prop Shaft - C&C 27

Peter, Regarding the Indigo prop – in addition to my C&C, I have another boat, a Ranger 29 (6700 pounds empty), with an A4 and the Indigo prop. I can’t compare to the original prop, but I must say the current A4/Indigo combination easily pushes the boat along at hull speed through some serious

Re: Stus-List lyn &larry pardy electrical

Excellent Wally I always wondered why anyone would cruise in such a minimalist fashion for so many years!! Thanks for the chuckle :-). Mike -Original Message- From: Wally Bryant [mailto:w...@wbryant.com] Sent: Thursday, December 19, 2013 12:23 PM To: cnc-list@cnc-list.com Subject:

Re: Stus-List CS 30 PHRF rating - Was: New boat - CS30

Sounds like the normal aging process to me... :-). Mike -Original Message- From: Wally Bryant [mailto:w...@wbryant.com] Sent: Tuesday, November 12, 2013 8:24 AM To: cnc-list@cnc-list.com Subject: Re: Stus-List CS 30 PHRF rating - Was: New boat - CS30 Joe wrote: > Every time this comes up

Re: Stus-List Yanmar 3GMF Starting Problem

This is a well known problem with Yanmar engines. I had exact same symptom on a previous boat (Yanmar 2gm20f). Apparently, the wiring from the starter switch to the starter solenoid is NOT QUITE adequate to always energize the solenoid. It can be fixed by adding an additional relay. See the

Re: Stus-List Sky-liners

Charlie, Assuming your setup is similar to mine, you do have to remove the spray hood which covers the hatch rails. I've had mine off three different times trying to fix the leak I mentioned without removing the skylight itself. No dice. So I'm reinstalling the skylight "correctly" after whic

Re: Stus-List C&C 30 mk II skylight

Yes, Ken is correct, the skylight is directly bonded to the flat surface of the deck. I have removed it as well as all of the original adhesive used to attach it. I will be rebonding it next week with Sika 295iUV. I'm hoping that will take care of a leak that has found its way in between th

Stus-List C&C 30 mk II skylight

I've read many of the postings regarding rebedding windows and ports. My question is specifically about the skylight just forward of the companionway in the C&C 30 mk II. Does anyone know what this is made of? I'd like to remove and reattach it and I'm wondering if Sika 295 with appropriate p

Re: Stus-List Introduction and gastric reflux

< but one does worry about the errant flying fish. > HaHa... good one, Martin :). Mike 1989 C&C 30 mk II Echappe' ___ This List is provided by the C&C Photo Album http://www.cncphotoalbum.com CnC-List@cnc-list.com

Re: Stus-List Springerizing the boat

I think it depends upon how the tanks are drained. Unless you actually disconnect some hoses, it is difficult to know that you are draining them completely. An alternate procedure is to run the freshwater pump until the faucets pretty much stop spitting, then put a couple of gallons of antifr

Re: Stus-List Economic justification for owning a boat

I think the way to look at it is, “yes, it’s damned expensive, but one has got to have fun in life!!” Besides, as someone already pointed out, it’s cheaper than therapy! Mike C&C 30 mk II Echappe’ From: Gary Nylander [mailto:gnylan...@atlanticbb.net] Sent: Thursday, February 21, 2013 7:11 AM