>>>> ## Booting kernel from Legacy Image at 1200 ...
>>>> Image Name: boot
>>>> Image Type: ARM Linux Kernel Image (uncompressed)
>>>> Data Size:3756516 Bytes = 3.6 MiB
>>>> Load Address: 1080
>>>> Entry Point:
mage Type: ARM Linux Kernel Image (uncompressed)
>>> Data Size:3756516 Bytes = 3.6 MiB
>>> Load Address: 1080
>>> Entry Point: 1080
>>> Verifying Checksum ... OK
>>> Loading Kernel Image ... OK
>>> OK
>>> No gpc device no
t; Hello,
>>>
>>> do you have to install u-boot on an SD card?
>>>
>>> If so, then the miniroot doesn’t work for you. That particular miniroot
>>> expects the board to boot from a u-boot flashed onto an on-board chip.
>>>
>>> What you c
t;> do you have to install u-boot on an SD card?
>>
>> If so, then the miniroot doesn’t work for you. That particular miniroot
>> expects the board to boot from a u-boot flashed onto an on-board chip.
>>
>> What you can do is flash u-boot to an SD card, put the IMX um
and boot it via
> „bootm“.
>
> \Patrick
>
> Am 17.09.2014 um 14:44 schrieb Hrishikesh Muruk :
>
> > Hello
> >
> > I am trying to boot OpenBSD on a Freescale iMX6 SABRE Smart Devices
> board.
> > This is not the same as SABRE Lite.
> >
> &
to load it into u-boot memory and boot it via „bootm“.
\Patrick
Am 17.09.2014 um 14:44 schrieb Hrishikesh Muruk :
> Hello
>
> I am trying to boot OpenBSD on a Freescale iMX6 SABRE Smart Devices board.
> This is not the same as SABRE Lite.
>
> I followed instr
Hello
I am trying to boot OpenBSD on a Freescale iMX6 SABRE Smart Devices board.
This is not the same as SABRE Lite.
I followed instructions at:
http://ftp.openbsd.org/pub/OpenBSD/5.5/armv7/INSTALL.armv7
I copied the miniroot-imx-55.fs file my SD card using dd. I don't see any
output on
