Hi, On Saturday 02 September 2006 22:13, Wolfram Heider wrote: > On Sat, 02 Sep 2006 00:40:42 +0200, Warren Post <war...@copaninvest.com> > wrote: > > > My Canon CanoScan LiDE 25 is found by sane-find-scanner but not by > > scanimage (using sane-frontends-1.0.13-2mdk, xsane-0.97-2mdk, and > > sane-backends-1.0.17-2.1.20060mdk on Mandriva 2006). So far I have done > > the following: > > > > 1. Downloaded and installed a version of sane-backends (1.0.17) that > > supports the LiDE 25 to replace my older 1.0.16. > > > > 2. Insured that the scanner is seen by the USB subsystem and reports > > information consistent with man sane-plustek: > > > > [warren@gerencia ~]$ lsusb > > Bus 001 Device 002: ID 04a9:2220 Canon, Inc. > > Bus 001 Device 001: ID 0000:0000 > > > > 3. Modified /etc/sane.d/plustek.conf per man sane-plustek. > > Specifically, I added the line "[usb] 0x04a9 0x2220". I have tried both > > "device auto" and not having a device line. > > the entry should read "device /dev/usbscanner"
Nope, [usb] 0x04a9 0x2220 is oaky > > > > 4. Insured that sane-find-scanner sees the LiDE 25 and reports > > information consistent with man sane-plustek: > > > > [warren@gerencia ~]$ sane-find-scanner [snip] > > found USB scanner (vendor=0x04a9 [Canon], product=0x2220 [CanoScan], > > chip=LM9832/3) at libusb:001:002 > > > > 5. Run "scanimage -L" with debugging on, looking for clues. I can send > > the entire lengthy output if desired, but what jumps out at me is: > > > > [warren@gerencia ~]$ export SANE_DEBUG_PLUSTEK=24 > > [warren@gerencia ~]$ export SANE_DEBUG_DLL=24 > > [warren@gerencia ~]$ export SANE_DEBUG_SANEI_USB=24 > > [warren@gerencia ~]$ scanimage -L > > [snip] > > [plustek] Checking for 0x04a9-0x2206 > > [plustek] Checking for 0x04a9-0x2207 > > [plustek] Checking for 0x04a9-0x2208 > > [plustek] Checking for 0x04a9-0x220d > > [plustek] Checking for 0x04a9-0x220e > > [plustek] Available and supported devices: > > [plustek] NONE. > > [snip] here you are - your version does not support the LiDE25!!!, you still use 1.0.16. Please check your installation - probably some crappy double installation. I don't recall, when I've integrated the LiDE25 support, so you might upgrade to 1.0.18, where the scanner is supported. Gerhard [SNIPSNAP]
