Hello Russ, OK. Now I am sure that the driver uses the correct values. It is not a problem of the sane-umax driver. I guess it is a configuration problem of the scsi controller. Please make sure that you disabled "disconnect/reconnect" in the setup or configuration of your scsi controller - at least for the device ID of the scanner.
When this does not help then we have to take a closer look at your scsi chain (termination, cable length, etc.) Oliver Am Freitag, 13. Februar 2004 17:26 schrieb Russ Pitman: > Oliver Rauch wrote: > > Hello Russ, > > > > you removed almost all comments in the default umax.conf file (see > > attached part of your log). This is really bad. Please use the origin= al > > umax.conf file, this should work. > > > > Oliver > > From reading the various docs I was under the impression that > /etc/sane.d/umax.conf needed/required editing, however no problem. I h= ave > replaced /etc/sane.d with the files from the debian package and re run = the > commad SANE_DEBUG_UMAX=3D255 SANE_DEBUG_SANEI_SCSI=3D255 scanimage -d > umax:/dev/scanner 2> debug.txt > The gzipped file is attached' > From inspection: The lamp never moves,the scanner goes to led off (busy > mode?) > > I don't see any untoward comments in /var/log/messages referencing the > advansys scsi card. > > > The relevant part of your logfile: > > > > [sanei_scsi] sanei_scsi_open: open of `Options for the umax backend' > > failed: No such file or directory > > [umax] ERROR: attach_scanner: opening scsi device Options for the uma= x > > backend failed > > [umax] option scsi-maxqueue =3D 2 > > [umax] option scsi-buffer-size-min =3D 65536 > > [umax] option scsi-buffer-size-max =3D 262144 > > [umax] option scan-lines =3D 100 > > [umax] option preview-lines =3D 20 > > [umax] option handle-bad-sense-error =3D 0 > > [umax] option execute-request-sense =3D 0 > > [umax] option force-preview-bit-rgb =3D 0 > > [umax] option slow-speed =3D 0 > > [umax] option care-about-smearing =3D 0 > > [umax] option calibration-full-ccd =3D 1 > > [umax] option calibration-width-offset =3D -99999 > > [umax] option calibration-bytes-pixel =3D -1 > > [umax] option exposure-time-rgb-bind =3D 0 > > [umax] option invert-shading-data =3D 0 > > [umax] option lamp-control-available =3D 0 > > [umax] option gamma-lsb-padded =3D 0 > > [umax] option connection-type =3D 1 > > [umax] attach_scanner: /dev/sg1, connection_type 1 > > [umax] attach_scanner: opening scsi device /dev/sg1 > > If /etc/umax.conf isn't in the loop I guess there is no point in my > including it at this point? --=20 http://www.xsane.org http://www.rauch-domain.de http://www.sane-project.org
