Hello everybody,
I just have a scanner from a friend and I want to configure it under my
computer.I've installed it under this fuckin' windows98 without any problem.
My configuration is :
PII 350
256 Mo ram pc100
Graphics: 3D prophet II MX PCI
Network: Realtek Semiconductor RTL-8139 PCI
...and Linux Mandrake 8.1 (kernel 2.4.8)
about Scanner:
Mustek 600 II CD with 3151P scsi cards (on ISA port ...it was include with)
For this moment, i've installed mdk rpms (front-end & back-end).
When I tape
[root@drfazor drfazor]# sane-find-scanner
# Note that sane-find-scanner will find any scanner that is connected
# to a SCSI bus. It will even find scanners that are not supported
# at all by SANE. It won't find a scanner that is connected to a
# parallel, USB or other non-SCSI port.
# If your scanner uses SCSI, you must have a driver for your SCSI
# adaptor and support for SCSI Generic (sg) in your Operating System
# in order for the scanner to be used with SANE. If your scanner is
# NOT listed above, check that you have installed the drivers.
[root@drfazor drfazor]#
With a sane-find-scanner -v, it failed to open all the device.After research
in /dev this output don't exist.
How can I do for create one and link it to my scanner?
Thanks a lot for your help.
Dr Fazor
