Is it pip install --no-build-isolation --editable . and straight to step 7 in the README (make configure) then?
On Thursday, March 19, 2026 at 10:02:08 AM UTC+9 [email protected] wrote: > If you use Conda then you should not run ./configure. > > <https://doc.sagemath.org/html/en/installation/source.html#using-conda> > > > On March 18, 2026 7:39:42 PM CDT, "Seohyeon “Alex” Lee" < > [email protected]> wrote: > >> I used miniforge. The recommendations say 'conda install' but what I >> actually did was 'mamba install -c conda-forge [packages that showed up in >> recommendations...] >> >> On Thursday, March 19, 2026 at 6:55:38 AM UTC+9 [email protected] wrote: >> >>> Do want to use Conda for your Sage installation? >>> If not, you should isolate your Conda install from Sage (deactivate >>> the environment, make sure that it's not in the PATH, etc) >>> If yes, you seem to be following a wrong procedure. >>> >>> >>> On Wed, Mar 18, 2026 at 2:37 PM Seohyeon “Alex” Lee >>> <[email protected]> wrote: >>> > >>> > I have a Mac M1 and I'm working on building Sage from source. I >>> followed the instructions from the README page and the linked >>> documentation, but noticed I keep getting recommendations like the >>> following at the end of ./configure. >>> > ``` >>> > config.status: creating convenience symlink venv -> >>> local/var/lib/sage/venv-python3.12.5 >>> > real_configure: >>> > >>> > notice: the following SPKGs did not find equivalent system packages: >>> > >>> > cypari fpylll mathjax pplpy primecountpy python3 4ti2 _develop >>> _recommended coxeter3 free_fonts fricas gp2c igraph msolve onetbb >>> perl_cpan_polymake_prereq perl_mongodb perl_term_readline_gnu polymake >>> texlive texlive_luatex xindy >>> > >>> > checking for the package system in use... conda >>> > real_configure: >>> > >>> > hint: installing the following system packages, if not >>> > already present, is recommended and may avoid having to >>> > build them (though some may have to be built anyway): >>> > >>> > $ conda install mathjax >>> > >>> > real_configure: >>> > >>> > hint: installing the following system packages, if not >>> > already present, may provide additional optional features: >>> > >>> > $ conda install 4ti2 openssh pycodestyle esbonio open-fonts igraph tbb >>> > >>> > real_configure: >>> > >>> > hint: After installation, re-run configure using: >>> > >>> > $ make reconfigure >>> > ``` >>> > If I try installing the packages mentioned here, I get >>> > ``` >>> > Transaction >>> > >>> > Prefix: /Users/{myusername}/miniforge3/envs/sage-dev >>> > >>> > All requested packages already installed >>> > ``` >>> > If I ignore this and run make, I end up in the same loop. What can I >>> do to break out of this cycle? >>> > >>> > -- >>> > You received this message because you are subscribed to the Google >>> Groups "sage-devel" group. >>> > To unsubscribe from this group and stop receiving emails from it, send >>> an email to [email protected]. >>> > To view this discussion visit >>> https://groups.google.com/d/msgid/sage-devel/13ee0a53-7c1d-4a52-accd-16343c9a8866n%40googlegroups.com. >>> >>> >>> >> -- You received this message because you are subscribed to the Google Groups "sage-devel" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion visit https://groups.google.com/d/msgid/sage-devel/f3937133-4509-4655-9ebf-741847a98b3bn%40googlegroups.com.
