that would be http://oss.oetiker.ch/rrdtool/doc/rrdgraph_graph.en.html
----- Original Message -----
From: "Simon Pickard" <[email protected]>
To: "Alex van den Bogaerdt" <[email protected]>
Cc: <[email protected]>
Sent: Tuesday, December 30, 2014 10:50 PM
Subject: Re: [rrd-users] MIN AVG MAX LAST Values
Excellent, works a treat. Can you point me in the direction of the man
page
for the GPRINT statments?
Thank you.
On 30 December 2014 at 21:19, Alex van den Bogaerdt
<[email protected]>
wrote:
Sorry, I misread your initial post. units-exponent is about the axis,
not
the legend.
You want to remove the %s from your GPRINT statements.
By including those you ask to get "m" (in this case)
----- Original Message ----- From: "Simon Pickard" <[email protected]>
To: "Alex van den Bogaerdt" <[email protected]>
Cc: <[email protected]>
Sent: Tuesday, December 30, 2014 9:45 PM
Subject: Re: [rrd-users] MIN AVG MAX LAST Values
Hello,
Thanks for the help...I have added --units-exponent 0 \ but still the
same.
The values don't normally show any units only m when between 0.00 and
-0.99.
I have attached an example.
On 30 December 2014 at 19:34, Alex van den Bogaerdt <
[email protected]>
wrote:
----- Original Message ----- From: "Simon Pickard" <[email protected]>
To: <[email protected]>
Sent: Tuesday, December 30, 2014 8:22 PM
Subject: [rrd-users] MIN AVG MAX LAST Values
Hello,
I am using rrdtool to graph reading from various temp sensors.
If a value goes between 0.00 & -0.99 the MIN AVG MAX or LAST values
shown
on the graph read as 876m for example rather than the degree reading.
You want 0.876 instead of 876m ?
Perhaps --units-exponent 0 can help. See http://oss.oetiker.ch/rrdtool/
doc/rrdgraph.en.html
HTH
Alex
_______________________________________________
rrd-users mailing list
[email protected]
https://lists.oetiker.ch/cgi-bin/listinfo/rrd-users
_______________________________________________
rrd-users mailing list
[email protected]
https://lists.oetiker.ch/cgi-bin/listinfo/rrd-users
