Excellent, works a treat. Can you point me in the direction of the man page for the GPRINT statments?
Thank you. On 30 December 2014 at 21:19, Alex van den Bogaerdt <a...@vandenbogaerdt.nl> wrote: > Sorry, I misread your initial post. units-exponent is about the axis, not > the legend. > > You want to remove the %s from your GPRINT statements. > By including those you ask to get "m" (in this case) > > > ----- Original Message ----- From: "Simon Pickard" <sim...@gmail.com> > To: "Alex van den Bogaerdt" <a...@vandenbogaerdt.nl> > Cc: <rrd-users@lists.oetiker.ch> > Sent: Tuesday, December 30, 2014 9:45 PM > Subject: Re: [rrd-users] MIN AVG MAX LAST Values > > > > Hello, >> >> Thanks for the help...I have added --units-exponent 0 \ but still the >> same. >> >> The values don't normally show any units only m when between 0.00 and >> -0.99. >> >> I have attached an example. >> >> >> On 30 December 2014 at 19:34, Alex van den Bogaerdt < >> a...@vandenbogaerdt.nl> >> wrote: >> >> >>> ----- Original Message ----- From: "Simon Pickard" <sim...@gmail.com> >>> To: <rrd-users@lists.oetiker.ch> >>> Sent: Tuesday, December 30, 2014 8:22 PM >>> Subject: [rrd-users] MIN AVG MAX LAST Values >>> >>> >>> Hello, >>> >>>> >>>> I am using rrdtool to graph reading from various temp sensors. >>>> >>>> If a value goes between 0.00 & -0.99 the MIN AVG MAX or LAST values >>>> shown >>>> on the graph read as 876m for example rather than the degree reading. >>>> >>>> >>> You want 0.876 instead of 876m ? >>> >>> Perhaps --units-exponent 0 can help. See http://oss.oetiker.ch/rrdtool/ >>> doc/rrdgraph.en.html >>> >>> HTH >>> Alex >>> >>> >>> _______________________________________________ >>> rrd-users mailing list >>> rrd-users@lists.oetiker.ch >>> https://lists.oetiker.ch/cgi-bin/listinfo/rrd-users >>> >>> >> >
_______________________________________________ rrd-users mailing list rrd-users@lists.oetiker.ch https://lists.oetiker.ch/cgi-bin/listinfo/rrd-users
