Normally I would agree and have even gone down that path in my
troubleshooting. However, I installed and ran RH6.2 w/o an issue. Even
following the 7.0 I did a fresh 6.2 install just to make sure and it worked
fine. Reinstalled 7.0 and had problems again...it's really wierd..
the thing that I would add is that when I power it off it still does not
work "right" I still get most of the same errors they just appear later in
the boot cycle.
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Mikkel L. Ellertson
Sent: Monday, February 05, 2001 12:55 PM
To: [EMAIL PROTECTED]
Subject: RE: RH 7.0 install problem
On Mon, 5 Feb 2001, shoe wrote:
> Okay the saga continues...
>
> If I power off the machine and leave it for a while it MAY start up
however
> it gives a segmentation fault for just about every service it starts. Most
> of the time though it will not start. It is giving the segmentation fault
> errors prior to the problems spawning the gettys. Here is the one that
seems
> to be a common thread
>
[snip]
>
> help.
>
>
Time to start looking for hardware problems! The first thing I would
run is memtest86! When powering off the machine for a period of time
changes the way it behaves, the problem is not software. It sounds like
something is tempature sensitive, and letting the machine cool off lets
it work for a while.
Mikkel
--
Do not meddle in the affairs of dragons,
for you are crunchy and taste good with ketchup.
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list
_______________________________________________
Redhat-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-list