DMA(Ultra66) Have Kernel 2.3.3 but error on
compile....
Ok well I installed Linux on my machine: P-III 500mhz 128mb Ram 20gb HD 1gb HD Both
are connected to the Promise
Ultra66 DMA controller. And so now I have to type linux ide2=0x10e0, ide3=0x10d4 into
lilo every time I boot. I read that I
should get a Dev kernel in the 2.3.x range. So I downloaded 2.3.2 and extracted it and
everything. I know I have the complete
file but when I go to compile I get an error. make config works just fine. I go
through that just fine. But make dep; make clean;
(<-those work) make zImage; (also tried make bzImage) but it comes up with an error
like: can't open errorno.h in a directory.
I can post the exact message if needed. But what could be causing this? And is there
an easier way other than patching 20
times?
I'm running RH 6.2 w/ the 2.2.14-5.0 kernel. What can I do?
Thanks, Chris
--
thanks,
ViRi- mailto:[EMAIL PROTECTED]
_______________________________________________
Redhat-devel-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-devel-list
