First,
disable one of the scsi card detection in the bios....then continue
installation ..after finish installation...enable back the scsi in the
bios..but remember during installtion..you must install KUDZU ....after you
enable...then wait until kudzu detect it ..then you can use it....that's what
i do with my gateway alr8300
Nitebirdz wrote:
> I got a problem during the installation of Red Hat 6.1 and need some help,
> please. I try to install directly from the CD on a system that has a
> Seagate SCSI hard drive, and the initrd images seems to load fine, then it
> calls the aic7xxx module driver and it simply hangs. It does not do
> anythihg else.
>
> I already tried passing the following parameter at the boot prompt:
>
> linux aic7xxx=no_reset
>
> Any help or suggestions would be appreciated.
>
> ------------------------------
> Nitebirdz
> http://www.linuxnovice.org
> Tips, articles, news, links...
>
> _______________________________________________
> Redhat-devel-list mailing list
> [EMAIL PROTECTED]
> https://listman.redhat.com/mailman/listinfo/redhat-devel-list
--
yuzz
System Engineer
EmasOnline Dot Com Sdn. Bhd.
http://www.EmasOnline.com
[EMAIL PROTECTED]
Tel No: 606 - 3345666 ext 2174
Fax No: 606 - 3372233
"EveryDay Linux"
_______________________________________________
Redhat-devel-list mailing list
[EMAIL PROTECTED]
https://listman.redhat.com/mailman/listinfo/redhat-devel-list
