Considering slot/board alignment, ribbon cable, sensor and poor
visibility when attempting either a board change or fan swap on a VFX
Flex Power 3 or 4, if you're doing it on one of the FX's in the middle,
leaving on the wall may not work out so well. Might be time to pull it off.
Jerry, so is the nylon wire tie idea to allow the casting
to push in the ribbon cable a little as the case slides past it without
catching on it?
And I think it was Ray about replacing boards when the fan
dies. I've had fans die in 5-6 years and boards last 15+ years though
it does depend on how old everything is and the condition of those pesky
relay covers. Both boards are a lot more money than just the fan if the
situation doesn't qualify for yanking boards.
Bill
Feather River Solar Electric
Bill Battagin, Owner
4291 Nelson St.
Taylorsville, CA 95983
530.284.7849
CA Lic 874049
www.frenergy.net
On 2/15/2021 12:20 PM, Jerry Shafer wrote:
Thats the only way I have done repairs and service, why fight the
weight if you don't need to plus its just more to do.
On Mon, Feb 15, 2021, 8:02 AM <toddc...@finestplanet.com
<mailto:toddc...@finestplanet.com>> wrote:
has anyone successfully done this without removing the inverter
from the wall?
todd
--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
List sponsored by Redwood Alliance
List Address: RE-wrenches@lists.re-wrenches.org
Change listserver email address & settings:
http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org
There are two list archives for searching. When one doesn't work, try the other:
https://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/
http://lists.re-wrenches.org/pipermail/re-wrenches-re-wrenches.org
List rules & etiquette:
http://www.re-wrenches.org/etiquette.htm
Check out or update participant bios:
http://www.members.re-wrenches.org
